SAJ Sununo-TL Series Manual de instalación

Installation Manual SAJ Solar Inverter Sununo-TL Series Sununo-TL1.5K\Sununo-TL2K\Sununo-TL3KB\Sununo-TL4KB Sununo-TL3KA\Sununo-TL4KA\ Sunu

8 3.4 Special Installation (only for France) Connect the ground wire to the earthing, terminal, and then tighten them as following figure. Figure

9 4 Electrical Connection 4.1 Overview of connection area Sununo-TL1.5K/2K Sununo-TL3KB/4KB

10 Sununo-TL3KA/4KA/5K Figure 4.1 Object Description A DC switch to turn off the inverter manually(optional) B DC input C Plug for connecting t

11 Assembly Instructions: 1) Strip the cable with the length 0.276 inches (9/32″) - (7mm) and please be careful NOT to nick conductors. Figure 4.

12 Figure 4.5 Connect L, N and protective conductor to the AC terminal in accordance with the label. To do this, the insulated earthling conduct

13 6) Finally, connect the straight plug to the AC terminal on inverter. Pay attention to the polarity of the terminals to avoid wrong connecti

14 Male side connector (M) Female side connector (F) Figure 4.8 Assembly Instructions: 1) Strip the cable with the length 0.

15 Pin contact Socket contact Figure 4.12 Figure 4.13 4) Crimp contact barrel by using the hex crimping die, ensure it is fixed.See below figure

16 Figure 4.16 2) Wrest the cap by using the torque of 2.6~2.9N·m. Figure 4.17 3) After wrested the cap tightly, align the 2 half connectors

17 Check the insulation status between solar panels and ground. Make sure the DC side ground insulation is larger than 1000kΩ; otherwise it is forbi

Index 1 Introduction ... 1 2

18 Figure 6.2 Object Description A LED light – POWER. Yellow light shines when the inverter is energized. B LED light-FAULT. Red light shines w

19 7 Contact SAJ Guangzhou Sanjing Electric Co., Ltd. Add:No.17, Xiangshan Road Guangzhou Science City, Guangdong, China P.R.C. Zip: 510663 http://

1 1 Introduction This manual introduces the installation and configuration of below models of SAJ Solar Inverters. Sununo-TL1 .5K\Sununo-TL2K\Sunun

2 2 Assembly Parts After you receive the SAJ Solar Inverter, please check if there is any damage on the carton. Please also check the inside comple

3 Object Quantity Description A 1 SAJ Solar Inverter B 1 Rear Panel C 1 Sets 2Sets DC Connector (for Sununo-TL1.5K/2K） DC Connector (for Sununo

4 3 Installation 3.1 Installation Mode Avoid prolonged rain.Avoid direct sunlight. Ensure sufficient airflo

5 Figure 3.1 3.2 Safety Clearance Please follow up the safety clearance below when install one or multiple SAJ Solar Inverter. Please contact SA

6 Sununo-TL1.5K/2K Sununo-TL3KB/4KB Sununo-TL3KA/4KA Sununo-TL5K Figure 3.3 2) Drill 6 ho

7 Figure 3.5 4) Carefully attach the inverter to the rear panel according to the position of the screws. Make sure the backside of the inverter is